Drill bits Grinder ERA 3

The Air Grinders require a clean and dry air supply of a minimum 60 psi and 29 cfm passing through an in-line oiler to supply lubrication to the grinder. Also, a supply of water from a mains supply or a sump is required to act as a coolant during the grinding process. A full spares back-up service is also available. Available with a choice of Hemispherical, Ballistic Semi Ballistic, Paraboloid or Conical pins, in sizes 6mm to 25mm, a full spares back-up service is also available.

Electric Button Bit Grinder Machine ERA-3

Max. Spindle Speed 24000rpm Electric power data single phase 220V-240V 50 or 60 Hz 16Amps . Working air pressure 5-7 bar (100 psi) Air Consumption <0.03m3/min (<1 cfm) Rated power(motor) 3.2kw Water connection 6mm water hose Coolant / flushing medium water Grinder Dimensions: 1200x1130x1 780mm Weight excl. packaging 540Kg Weight incl. Packaging 600Kg Transport dimensions 1220*1220* 1900mm Sound Level 86 dB(A) Bit Holder Capacity Threaded Bit skirt diameter, 300mm(51/2″) Bit Holder Capacity Down the Hole Bit, shank diameter,max 190mm (5 1/2″)

Safety prescriptions

The installation, maintenance, and utilization of the machine is reserved to specialized staff.

Before making any cleaning or maintenance intervention verify having disconnected the power supply.

Do not remove the fixed protections of the machine protecting the mobile elements.

Do not put the hands in the parts where there is danger of crushing and/or trapping.

The operator should stay by the controls group in the most distant and protected position.

The make and control the working operations the operator has to position himself always behind the controls group.

The handling of the machine or part of it has to be made with the machine idle, the power supply disconnected, by specialized staff with the appropriate tools.

If it is necessary to replace the machine components, use original spare parts exclusively.

 

PREVENTION MEASURES AND INSTRUSTIONS FOR MACHINES OPERATORS

BEFORE USE:

Check that the machine is stable and that the grinder is correctly and tightly fitted to the machine.

Check the integrity of the guards protecting parts in motion.

 

DURING USE:

Report immediately any inappropriate functioning or dangerous situations;

The operator’s position needs to be such as not to be in contact with the parts in movement;

Do not remove or modify protection devices;

Do not intervene on mobile parts during the functioning of the machine;

Do not get distracted.

 

AFTER USE:

Correctly position the machine without leaving the tool suspended;

Carry out the review and maintenance operations needed to reuse the machine with the power supply disconnected;

In the maintenance operations comply with the indications of this manual;

Clean the machine.